- Clean the inside of the fan and
the tip of the adapter with alcohol to remove any grease
- Apply a drop of Gorilla Glue if
you want extra security
- Start the adapter in the center
hole
|
 |
|
 |
- Use the wrench to align the set
screws with the cut-out on the fan edge
- Push it in a little to hold the
position
|
- Turn the fan over on a hard
surface
- GENTLY but firmly push down
with your palm
|
 |
|
 |
- Make sure the setscrews are
lined up with the cutouts
- If they aren't lined up
properly use the wrench to rotate it into position
|
